*** Installation instructions for xtic, version 1.12 ***
--------------------------------------------------------
To be able to install xtic, you need the XPM package. If this is
not present at your site, try to get it from ftp.x.org or, 
rather, from one of its mirror sites close to you. Also, the
installation procedure relies on the imake/xmkmf procedures.
Assuming everything is set up well at your site, do the following:

1) Edit configure.h in this directory if needed.

2) Edit the Imakefile in this directory if needed.

3) Execute the following commands
	xmkmf -a
	make

Monitor the output of the above commands for error messages.
If no errors occured you my now test the program by stepping
into the src directory and entering xtic.
 
4) If you want to install the binary file xtic and the manual 
   file xtic.man, do:
 	make install
	make install.man
   Be aware that to put these files into their default directories
   (determined by imake) you normally have to be root. If you have
   the appropriate privileges, become root. Otherwise you may ask 
   someone else to do it or else edit the file configure.h to make
   imake put the files at another, non-privileged place. Then 
   you have to do "make clean" and start all over again from 1).

5) If you want to clean up the installation directory, do
	make clean


If something goes wrong for some reason (xmkmf is not properly
installed, the xpm library is misplaced etc.) then you will
have to edit the makefiles yourself and try to make it work...


Good Luck!

Mattias Jonsson